Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells

Tiantian Li; Xuemei Wu; Wanting Chen; Xiaoming Yan; Dongxing Zhen; Xue Gong; Jiafei Liu; Shaofeng Zhang; Gaohong He

doi:10.1016/j.cjche.2018.05.015

Your Location：

Home >

Browse articles >

Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells

Energy, Resources and Environmental Technology | Updated：2026-01-06

- Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells
- Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells
- 中国化学工程学报（英文版） 2018年26卷第10期页码：2130-2138
- Affiliations：
  
  2 School of Petroleum and Chemical Engineering, State Key Laboratory of Fine Chemicals, Research and Development Center of Membrane Science and Technology, Dalian University of Technology,Panjin,China,124221
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2018.05.015
  中图分类号：
- 纸质出版：2018
- Accepted：
Scan QR Code
Tiantian Li, Xuemei Wu, Wanting Chen, 等. Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells[J]. 中国化学工程学报（英文版）, 2018,26(10):2130-2138.

Tiantian Li, Xuemei Wu, Wanting Chen, Xiaoming Yan, Dongxing Zhen, Xue Gong, Jiafei Liu, Shaofeng Zhang, Gaohong He. Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells[J]. Chin.J.Chem.Eng., 2018, 26(10): 2130-2138.
Tiantian Li, Xuemei Wu, Wanting Chen, 等. Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells[J]. 中国化学工程学报（英文版）, 2018,26(10):2130-2138. DOI： 10.1016/j.cjche.2018.05.015.

Tiantian Li, Xuemei Wu, Wanting Chen, Xiaoming Yan, Dongxing Zhen, Xue Gong, Jiafei Liu, Shaofeng Zhang, Gaohong He. Poly (ether ether ketone ketone) based imidazolium as anion exchange membranes for alkaline fuel cells[J]. Chin.J.Chem.Eng., 2018, 26(10): 2130-2138. DOI： 10.1016/j.cjche.2018.05.015.

摘要

Abstract

An imidazolium functionalized poly (ether ether ketone ketone) (PEEKK-DImOH) anion exchange membrane (AEM) readily soluble in certain low-boiling-point solvents (isopropanol) is prepared. The solubility results are consistent with the results of molecular dynamics simulations. By varying the chloromethylation reaction temperature or concentrated sulfuric acid concentration of PEEKK

the degrees of chloromethylation of PEEKK are changed from 54% to 92%

the corresponding PEEKK-DImOH AEMs with the ion exchange capacities (IECs) of 1.14-1.65 mmol·g

-1

. The PEEKK-DImOH 92% AEM shows high hydroxide conductivity (31 mS·cm

-1

)

suitable water uptake (94%) and acceptable swelling ratio (39%) at 60℃. In addition

the PEEKK-DImOH AEMs possess good thermal and alkaline stability. The maximum power density (46.16 mW·cm

-2

) of fuel cell prepared with PEEKK-DImOH 92% AEM as exchange membrane and ionomer is much higher than that with commercial AHA membranes. All the above results indicate that the PEEKK used in this study is a promising AEM matrix material for alkaline fuel cells.

关键词

Keywords

references

浏览量

229

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Influence of the Surface and Structural Characteristics of Activated Carbons on Adsorptive Removal of Halo-Olefinic Impurities from 1,1,1,3,3-Pentafluoropropane

Proton conductivity performance and its correlation with physio-chemical properties of proton exchange membrane (PEM)

Measurement and Correlation of Vapor-Liquid Equilibrium for Binary System 1,2-Epoxycyclohexane+1,2-Dichloroethane

Advances in inorganic membranes for xylene isomers separation: Fabrication strategies and mechanistic insights

Novel polytriazole polymer membranes materials developed for the purification and separation of natural gas under high upstream feed pressure