Improving the performance of a thermoelectric power system using a flat-plate heat pipe

Suchen Wu; Yiwen Ding; Chengbin Zhang; Dehao Xu

doi:10.1016/j.cjche.2018.03.019

Your Location：

Home >

Browse articles >

Improving the performance of a thermoelectric power system using a flat-plate heat pipe

Fluid Dynamics and Transport Phenomena | Updated：2026-01-06

- Improving the performance of a thermoelectric power system using a flat-plate heat pipe
- Improving the performance of a thermoelectric power system using a flat-plate heat pipe
- 中国化学工程学报（英文版） 2019年27卷第1期页码：44-53
- Affiliations：
  
  2 Nanjing ACME Electronics Cooling Service Inc.,Nanjing,China,211101
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2018.03.019
  中图分类号：
- 纸质出版：2019
- Accepted：
Scan QR Code
Suchen Wu, Yiwen Ding, Chengbin Zhang, 等. Improving the performance of a thermoelectric power system using a flat-plate heat pipe[J]. 中国化学工程学报（英文版）, 2019,27(1):44-53.

Suchen Wu, Yiwen Ding, Chengbin Zhang, Dehao Xu. Improving the performance of a thermoelectric power system using a flat-plate heat pipe[J]. Chin.J.Chem.Eng., 2019, 27(1): 44-53.
Suchen Wu, Yiwen Ding, Chengbin Zhang, 等. Improving the performance of a thermoelectric power system using a flat-plate heat pipe[J]. 中国化学工程学报（英文版）, 2019,27(1):44-53. DOI： 10.1016/j.cjche.2018.03.019.

Suchen Wu, Yiwen Ding, Chengbin Zhang, Dehao Xu. Improving the performance of a thermoelectric power system using a flat-plate heat pipe[J]. Chin.J.Chem.Eng., 2019, 27(1): 44-53. DOI： 10.1016/j.cjche.2018.03.019.

摘要

Abstract

A gravitational flat-plate heat pipe is designed and fabricated in this paper to serve as a heat spreader to diffuse the local heat source to the hot side of the thermoelectric power module. Based on this

an experimental test for the thermoelectric power generation system is conducted to study the influences of the heat spreader on the temperature uniformity and power generation performance when exposing to a local heat source. In addition

the effects of the heating power

inclination angle

and local heat source size on the power generation performance of the thermoelectric power module using a flat-plate heat pipe as a heat spreader are examined and compared with that using a metal plate. The results indicate that the gravitational flat-plate heat pipe has considerable advantages over the metal plate in the temperature uniformity. The superiority of temperature uniformity in the improvement of power generation performance for the thermoelectric power system using a heat pipe is demonstrated. Particularly

the heat pipe shows good adaptability to placement mode and the local heat source size

which is beneficial to the application in the thermoelectric power generation.

关键词

Keywords

references

浏览量

384

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

A review of low-temperature heat recovery technologies for industry processes

Recent Advances in Flame Tomography

Integration of Low-level Waste Heat Recovery and Liquefied Nature Gas Cold Energy Utilization

Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis

Experimental and numerical studies of holdup and velocity behavior for inclined bubbly oil-water pipe flows