Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)

M. Hatami; M. J. Z. Ganji; I. Sohrabiasl; D. Jing

doi:10.1016/j.cjche.2016.10.022

Your Location：

Home >

Browse articles >

Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)

Fluid Dynamics and Transport Phenomena | Updated：2026-01-06

- Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)
- Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)
- 中国化学工程学报（英文版） 2017年第6期页码：722-731
- Affiliations：
  
  1. International Research Center for Renewable Energy, State Key Laboratory of Multiphase Flow in Power Engineering, Xi'an Jiaotong University,Xi'an,China,710049
  2. Department of Mechanical Engineering, Esfarayen University of Technology, Esfarayen, North Khorasan,Iran
  3. Department of Renewable Energies Engineering, Faculty of New Sciences & Technologies, University of Tehran, Tehran,Iran
  4. Department of Mechanical Engineering, Babol University of Technology, Babol,Iran
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2016.10.022
  中图分类号：
- 纸质出版：2017
- Accepted：
Scan QR Code
M. Hatami, M. J. Z. Ganji, I. Sohrabiasl, 等. Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)[J]. 中国化学工程学报（英文版）, 2017,(6):722-731.

M. Hatami, M. J. Z. Ganji, I. Sohrabiasl, et al. Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)[J]. Chinese Journal of Chemical Engineering, 2017, (6): 722-731.
M. Hatami, M. J. Z. Ganji, I. Sohrabiasl, 等. Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)[J]. 中国化学工程学报（英文版）, 2017,(6):722-731. DOI： 10.1016/j.cjche.2016.10.022.

M. Hatami, M. J. Z. Ganji, I. Sohrabiasl, et al. Optimization of the fuel rod's arrangement cooled by turbulent nanofluids flow in pressurized water reactor (PWR)[J]. Chinese Journal of Chemical Engineering, 2017, (6): 722-731. DOI： 10.1016/j.cjche.2016.10.022.

摘要

Abstract

In this paper

response surface methodology (RSM) based on central composite design (CCD) is applied to obtain an optimization design for the fuel rod's diameter and distance cooled by turbulent Al

-water nanofluid for a typical pressurized water reactor (PWR). Fuel rods and nanofluid flow between them are simulated 3D using computational fluid dynamics (CFD) by ANSYS-FLUNET package software. The RNG

k-ε

model is used to simulate turbulent nanofluid flow between the rods. The effect of different nanoparticles concentration is also investigated on the Nusselt number from heat transfer efficiency view point. Results reveal that when distance parameter (

) is in the minimum level and diameter parameter (

) is in the maximum possible level

cooling the rods will be better due to higher Nusselt number in this situation. Also

using the different nanoparticles on the cooling process confirms that Al

averagely 17% and TiO

10% improve the Nusselt numbers.

关键词

Keywords

references

浏览量

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Optimization of natural convection heat transfer of Newtonian nanofluids in a cylindrical enclosure

Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis

Enhancing corrosion resistance of heat-assisted forming titanium bipolar plate for proton exchange membrane fuel cell through optimized heat treatment

Novel intensification strategy for the liquid-only transfer dividing wall column separating ternary mixtures based on the column grand composite curve

Source term estimation of hazardous gas leakages under turbulent atmospheric transport dispersion scenarios