Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration

Hong Wu; Tiantian Zhou; Xianshi Li; Cuihong Zhao; Zhongyi Jiang

doi:10.1016/j.cjche.2014.11.022

Your Location：

Home >

Browse articles >

Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration

分离科学与工程 | Updated：2026-01-06

- Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration
- Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration
- 中国化学工程学报（英文版） 2015年23卷第2期页码：372-378
- Affiliations：
  
  1. Key Laboratory for Green Chemical Technology, School of Chemical Engineering and Technology, Tianjin University,Tianjin,China,300072
  2. Collaborative Innovation Center of Chemical Science and Engineering (Tianjin),Tianjin,China,300072
  3. Tianjin Key Laboratory of Membrane Science and Desalination Technology, Tianjin University,Tianjin,China,300072
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2014.11.022
  中图分类号：
- 纸质出版：2015
- Accepted：
Scan QR Code
Hong Wu, Tiantian Zhou, Xianshi Li, 等. Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration[J]. 中国化学工程学报（英文版）, 2015,23(2):372-378.

Hong Wu, Tiantian Zhou, Xianshi Li, Cuihong Zhao, Zhongyi Jiang. Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration[J]. , 2015, 23(2): 372-378.
Hong Wu, Tiantian Zhou, Xianshi Li, 等. Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration[J]. 中国化学工程学报（英文版）, 2015,23(2):372-378. DOI： 10.1016/j.cjche.2014.11.022.

Hong Wu, Tiantian Zhou, Xianshi Li, Cuihong Zhao, Zhongyi Jiang. Enhancing the separation performance by introducing bioadhesive bonding layer in composite pervaporation membranes for ethanol dehydration[J]. , 2015, 23(2): 372-378. DOI： 10.1016/j.cjche.2014.11.022.

摘要

Abstract

A high performance composite membrane was prepared under the inspiration of bioadhesion principles for pervaporative dehydration of ethanol. Chitosan (CS) and polyacrylonitrile (PAN) ultrafiltration membranes were used as the active layer and the support layer

respectively. Guar gum (GG)

a natural bioadhesive

was introduced as the intermediate bonding layer to improve the separation performance and stability of the fabricated CS/GG/PAN composite membranes. The contact angle of the GG layerwas just between those of the CS layer and the PAN layer

minimizing the difference of hydrophilicity between the active layer and the support layer. The peeling strength of the composite membrane was significantly enhanced after the introduction of the GG layer. The effects of preparation conditions and operation conditions including GG concentration

operating temperature and ethanol concentration in feed on the pervaporation performance were investigated. The as-fabricated CS/GG/PAN composite membrane showed the optimum performance with a permeation flux of up to 804 g·m

-2

·h

-1

and a separation factor higher than 1900. Besides

the compositemembranes exhibited a desirable long-term operational

stability.

关键词

Keywords

references

浏览量

108

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Preparation and properties of antibacterial PVA@MCC composite membrane assisted by ionic liquids and DMSO

Thermal conductivity of PVDF/PANI-nanofiber composite membrane aligned in an electric field

Impregnation of carbonaceous nanofibers into glassy polymer-based composite membrane for CO2 separation

Recent advances on mixed matrix membranes for CO2 separation

Enhancing Structural Stability and Pervaporation Performance of Composite Membranes by Coating Gelatin onto Hydrophilically Modified Support Layer