Sajad Khamis Abadi, Mohammad Hasan Khoshgoftar Manesh, Marc A. Rosen, 等. Integration of a Gas Fired Steam Power Plant with a Total Site Utility Using a New Cogeneration Targeting Procedure[J]. 中国化学工程学报(英文版), 2014,22(4):455-4681004-954160054-9.
Sajad Khamis Abadi, Mohammad Hasan Khoshgoftar Manesh, Marc A. Rosen, Majid Amidpour, Mohammad Hosein Hamedi. Integration of a Gas Fired Steam Power Plant with a Total Site Utility Using a New Cogeneration Targeting Procedure[J]. Chin.J.Chem.Eng., 2014, 22(4): 455-468.
Sajad Khamis Abadi, Mohammad Hasan Khoshgoftar Manesh, Marc A. Rosen, 等. Integration of a Gas Fired Steam Power Plant with a Total Site Utility Using a New Cogeneration Targeting Procedure[J]. 中国化学工程学报(英文版), 2014,22(4):455-4681004-954160054-9.DOI: 10.1016/S1004-9541(14)60054-9.
Sajad Khamis Abadi, Mohammad Hasan Khoshgoftar Manesh, Marc A. Rosen, Majid Amidpour, Mohammad Hosein Hamedi. Integration of a Gas Fired Steam Power Plant with a Total Site Utility Using a New Cogeneration Targeting Procedure[J]. Chin.J.Chem.Eng., 2014, 22(4): 455-468.DOI: 10.1016/S1004-9541(14)60054-9.
Integration of a Gas Fired Steam Power Plant with a Total Site Utility Using a New Cogeneration Targeting Procedure
摘要
Abstract
A steam power plant can work as a dual purpose plant for simultaneous production of steam and electrical power. In this paper we seek the optimum integration of a steam power plant as a source and a site utility system as a sink of steam and power. Estimation for the cogeneration potential prior to the design of a central utility system for site utility systems is vital to the targets for site fuel demand as well as heat and power production. In this regard
a new cogeneration targeting procedure is proposed for integration of a steam power plant and a site utility consisting of a process plant. The new methodology seeks the optimal integration based on a new cogeneration targeting scheme. In addition
a modified site utility grand composite curve (SUGCC) diagram is proposed and compared to the original SUGCC. A gas fired steam power plant and a process site utility is considered in a case study. The applicability of the developed procedure is tested against other design methods (STAR
®
and Thermoflex software) through a case study. The proposed method gives comparable results
and the targeting method is used for optimal integration of steam levels. Identifying optimal conditions of steam levels for integrat
ion is important in the design of utility systems
as the selection of steam levels in a steam power plant and site utility for integration greatly influences the potential for cogeneration and energy recovery. The integration of steam levels of the steam power plant and the site utility system in the case study demonstrates the usefulness of the method for reducing the overall energy consumption for the site.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Integration of energy recovery network including recycling residual pressure energy with pinch technology
Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis
Enhancing corrosion resistance of heat-assisted forming titanium bipolar plate for proton exchange membrane fuel cell through optimized heat treatment
Novel intensification strategy for the liquid-only transfer dividing wall column separating ternary mixtures based on the column grand composite curve
Source term estimation of hazardous gas leakages under turbulent atmospheric transport dispersion scenarios
相关作者
Jianqiang Deng
Zheng Cao
Dongbo Zhang
Xiao Feng
Han Rui
Guan Qingshan
Gu Leqi
Sun Xiaoyan
相关机构
School of Chemical Engineering and Technology, Xi'an Jiaotong University
Shaanxi Coal and Chemical Technology Institute Co., Ltd
College of Chemical Engineering, Qingdao University of Science and Technology
Anhui Metaenergy Technologies Co., Ltd
Center of Ionic Liquid and Green Energy, Beijing Key Laboratory of Solid State Battery and Energy Storage Process, State Key Laboratory of Mesoscience and Engineering, Institute of Process Engineering, Chinese Academy of Sciences