Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels
Full Length Article|Updated:2026-01-06
|
Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels
Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels
中国化学工程学报(英文版)2024年65卷第1期 页码:230-242
Affiliations:
1. Key Laboratory for Green Chemical Technology of the Ministry of Education, School of Chemical Engineering and Technology, Tianjin University,Tianjin,China,300072
2. Collaborative Innovative Center of Chemical Science and Engineering (Tianjin),Tianjin,China,300072
3. Haihe Laboratory of Sustainable Chemical Transformations,Tianjin,China,300192
4. Zhejiang Institute of Tianjin University,Ningbo,China,315201
Author bio:
Funds:
DOI:
中图分类号:
纸质出版:2024
Accepted:
Scan QR Code
Yi Chen, Kang Xue, Yang Liu, 等. Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels[J]. 中国化学工程学报(英文版), 2024,65(1):230-242.
Yi Chen, Kang Xue, Yang Liu, Lun Pan, Xiangwen Zhang, Ji-Jun Zou. Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels[J]. Chinese Journal of Chemical Engineering, 2024, 65(1): 230-242.
Yi Chen, Kang Xue, Yang Liu, 等. Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels[J]. 中国化学工程学报(英文版), 2024,65(1):230-242.DOI:
Yi Chen, Kang Xue, Yang Liu, Lun Pan, Xiangwen Zhang, Ji-Jun Zou. Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels[J]. Chinese Journal of Chemical Engineering, 2024, 65(1): 230-242.DOI:
Preparation and properties of high-energy-density aluminum/boroncontaining gelled fuels
摘要
Abstract
Energetic nanofluid fuel has caught the attention of the field of aerospace liquid propellant for its high energy density (HED)
but it suffers from the inevitable solideliquid phase separation problem. To resolve this problem
herein we synthesized the high-Al-/B-containing (up to 30% (mass)) HED gelled fuels
with low-molecular-mass organic gellant Z
which show high net heat of combustion (NHOC)
density
storage stability
and thixotropic properties. The characterizations indicate that the application of energetic particles to the gelled fuels obviously destroys their fibrous network structures but can provide the new particleegellant gelation microstructures
resulting in the comparable stability between 1.0% (mass) Z/JP- 10 + 30% (mass) Al or B and pure JP-10 gelled fuel. Moreover
the gelled fuels with high-content Al or B exhibit high shear-thinning property
recovery capability
and mechanical strength
which are favorable for their storage and utilization. Importantly
the prepared 1.0% (mass) Z/JP-10 + 30% (mass) B (or 1.0% (mass) Z/JP-10 + 30% (mass) Al) shows the density and NHOC 1.27 times (1.30) and 1.43 times (1.21) higher than pure JP-10
respectively. This work provides a facile and valid approach to the manufacturing of HED gelled fuels with high content of energetic particles for gel propellants.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis
Recovery rubidium chloride and cyclic utilization of hexacyanoferrate(II) ion from hexacyanoferrate-internediate solutions via solvent extraction
Experimental and numerical studies of holdup and velocity behavior for inclined bubbly oil-water pipe flows
Preparation of novel hierarchical porous Fe2O3/SBA-15 with microporous plugs from coal gasification fine residue and its degradation of phenol in coal chemical wastewater
Synthesis of chemiluminescent carbonized polymer dots under atmospheric conditions for multimode luminescence anti-counterfeiting