Continuous generation of lattice oxygen via redox engineering for boosting toluene degradation performances
Resources and Environmental Technology|Updated:2026-01-06
|
Continuous generation of lattice oxygen via redox engineering for boosting toluene degradation performances
Continuous generation of lattice oxygen via redox engineering for boosting toluene degradation performances
中国化学工程学报(英文版)2021年34卷第6期 页码:258-266
Affiliations:
1. Department of Environment and Resources, Xiangtan University,Xiangtan,China,411105
2. State Key Laboratory of Heavy Oil Processing, College of Chemical Engineering, China University of Petroleum,Qingdao,China,266580
3. Beijing Engineering Research Center of Process Pollution Control, Division of Environment Technology and Engineering, Key Laboratory of Green Process and Engineering, Institute of Process Engineering, Chinese Academy of Sciences,Beijing,China,100190
Author bio:
Funds:
DOI:
中图分类号:
纸质出版:2021
Accepted:
Scan QR Code
Shiya He, Zhimin You, Xin Jin, 等. Continuous generation of lattice oxygen via redox engineering for boosting toluene degradation performances[J]. 中国化学工程学报(英文版), 2021,34(6):258-266.
Excellent performances promoted by lattice oxygen have attracted wide attention for catalytic degradation of volatile organic compounds (VOCs). However
how to control the continuous regeneration of lattice oxygen from the support is seldom reported. In this study
we selected sepiolite supported manganese-cobalt oxides (Co
x
Mn
100-
x
O
y
) as model catalysts by tuning Co/(Co + Mn) mass ratio (
x
= 3%
10%
15%
and 20%) to enhance toluene degradation efficiency
owing to lattice oxygen regeneration by redox cycle existing at the interface and Mn species with high valence state
initiated by cobalt catalytic performance under the role of crystal field stability phase. The results of activity test show that the sepiolite-Co
15
Mn
85
O
y
catalyst exhibit outperformances at 193 ℃ with 10
000 h
-1
GHSV. In addition
the catalyst existed at the bottom of the “volcano” curve correlated
T
50
or
T
90
with Co/(Co + Mn) weight ratio is sepiolite-Co
15
Mn
85
O
y
conforming its outperformance. Further characterized by investig
ating active sites structural and electronic properties
the essential of superior catalytic activity is attributed to the grands of lattice oxygen continuous formation resulted from redox engineering based on the high atomic ratio of surface lattice oxygen with continuous refilled from the support and that of Mn
4+
/Mn
3+
cycle initiated by cobalt catalytic behaviors. All in all
redox engineering
not only promotes grands of active species reversible regeneration
but supplies an alternative catalyst design strategy towards the terrific efficiency-to-cost ratio performance.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Chemical looping conversion of methane via Fe2O3-LaFeO3 calcined from LaFe-MOF precursor
Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis
CO2 leakage behavior from CO2 hydrate-liquid CO2-seawater coexistence system in unsealed sediments
Unraveling the methane decomposition mechanism on Fe-Ni-Ca-O composite catalysts: A combined density functional theory and microdynamic study
Preparation of novel hierarchical porous Fe2O3/SBA-15 with microporous plugs from coal gasification fine residue and its degradation of phenol in coal chemical wastewater
相关作者
Jitong Deng
Yongjun Zhang
Xiaopeng Wang
Wei Zhang
Hongjing Han
Haiying Wang
Huimin Yuan
Yanan Zhang
相关机构
College of Chemistry & Chemical Engineering, Northeast Petroleum University
PetroChina Daqing Petrochemical Research Center
CNPC Safety and Environmental Technology Research Institute Co. LTD.