Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature

Ali Piroozian; Muhammad A. Manan; Issham Ismail; Rahmat Mohsin; Ali Esfandyari Bayat; Mac Darlington Uche Onuoha; Mahmoud Hemmati

Your Location：

Home >

Browse articles >

Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature

第25届中国过程控制会议专栏 | Updated：2026-01-06

- Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature
- Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature
- 中国化学工程学报（英文版） 2016年第6期页码：795-802
- Affiliations：
  
  1. Department of Petroleum Engineering, Faculty of Petroleum and Renewable Energy Engineering, Universiti Teknologi Malaysia,Johor,Malaysia,81310
  2. 2 Malaysia Petroleum Resources Corporation(UTM-MPRC) Institute for Oil and Gas, Universiti Teknologi Malaysia,Johor,Malaysia,81310
  3. 3 Offshore Oil and Gas Research Center, College of Mechanical and Oil/Gas Transportation Engineering, China University of Petroleum,Beijing,China,102249
- Author bio：
- Funds：
  
  Supported by the Malaysia's Ministry of Higher Education (FRGS/4F136) and the University Teknologi Malaysia (RUG/01H68).
- DOI：
  中图分类号：
- 纸质出版：2016
- Accepted：
Scan QR Code
Ali Piroozian, Muhammad A. Manan, Issham Ismail, 等. Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature[J]. 中国化学工程学报（英文版）, 2016,(6):795-802.

Ali Piroozian, Muhammad A. Manan, Issham Ismail, et al. Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature[J]. Chinese Journal of Chemical Engineering, 2016, (6): 795-802.
Ali Piroozian, Muhammad A. Manan, Issham Ismail, 等. Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature[J]. 中国化学工程学报（英文版）, 2016,(6):795-802. DOI：

Ali Piroozian, Muhammad A. Manan, Issham Ismail, et al. Mixture temperature prediction of waxy oil-water two-phase system flowing near wax appearance temperature[J]. Chinese Journal of Chemical Engineering, 2016, (6): 795-802. DOI：

摘要

Abstract

Temperature sensitivity of waxy crude oils makes it difficult to study their flow behaviour in the presence of water especially near their wax appearance temperature (WAT). In this study a method was proposed and implemented to mitigate such difficulties which was applied in predicting mixture temperatures (T

) of a typical Malaysian waxy crude oil and water flow in a horizontal pipe. To this end

two analytical models were derived firstly from calorimetry equation which based on developed two correlations for defining crude oil heat capacity actualized from the existed specific heat capacities of crude oils. The models were then applied for a set of experiments to reach the defined three predetermined Tm (26℃

28℃ and 30℃). The comparison between the predicted mixture temperatures (T

and T

) from the two models and the experimental results displayed acceptable absolute average errors (0.80%

0.62%

0.53% for model 1; 0.74%

0.54%

0.52% for model 2).Moreover

the average errors for both models are in the range of standard error limits (±0.75%) according to ASTM E230. Conclusively

the proposed model showed the ease of obtaining mixture temperatures close to WAT as predetermined with a

ccuracy of ±0.5℃ approximately for over 84% of the examined cases. The method is seen as a practical reference point to further study the flow behaviour of waxy crudes in oil-water two-phase flow system near sensitive temperatures.

关键词

Keywords

references

浏览量

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Analytical Model for Predicting the Heat Loss Effect on the Pyrolysis of Biomass Particles

Optimizing energy efficiency in fluid catalytic cracking units with GA and NSGA-II: A comprehensive simulation and multi-factor analysis

Research on the electrostatic spray characteristics of ethanol/n-butanol blended fuels

Revealing critical factors in lignite-water interactions: From atomic to macroscopic

Preparation of novel hierarchical porous Fe2O3/SBA-15 with microporous plugs from coal gasification fine residue and its degradation of phenol in coal chemical wastewater