Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles
流体力学与传递现象|Updated:2026-01-06
|
Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles
Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles
中国化学工程学报(英文版)2015年23卷第3期 页码:461-470
Affiliations:
State Key Laboratory of Chemical Resource Engineering, School of Chemical Engineering, Beijing University of Chemical Technology,Beijing,China,100029
Author bio:
Funds:
DOI:
中图分类号:
纸质出版:2015
Accepted:
Scan QR Code
Wanbo Li, Xingye Geng, Yuyun Bao, 等. Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles[J]. 中国化学工程学报(英文版), 2015,23(3):461-470.
Wanbo Li, Xingye Geng, Yuyun Bao, Zhengming Gao. Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles[J]. , 2015, 23(3): 461-470.
Wanbo Li, Xingye Geng, Yuyun Bao, 等. Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles[J]. 中国化学工程学报(英文版), 2015,23(3):461-470.DOI:
Wanbo Li, Xingye Geng, Yuyun Bao, Zhengming Gao. Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles[J]. , 2015, 23(3): 461-470.DOI:
Micromixing characteristics in a gas-liquid-solid stirred tank with settling particles
The parallel-competing iodide-iodate reaction scheme was used to study the micromixing performance in a multi-phase stirred tank of 0.3m diameter. The impeller combination consisted of a half elliptical blade disk turbine below two down-pimping wide-blade hydrofoils
identified as HEDT+2WH
D
. Nitrogen and glass beads of 100 μm diameter and density 2500 kg·m
-3
were used as the dispersed phases. The micromixing could be improved by sparging gas because of its additional potential energy. Also
micromixing could be improved by the solid particles with high kinetic energy near the impeller tip. In a gas-solid-liquid system
the gas-liquid film vibrationwith damping
due to the frequent collisions between the bubbles and particles
led to the decrease of the turbulence level in the liquid and caused eventually the deterioration of themicromixing. A Damping Film Dissipation model is formulated to shed light on the above micromixing performances. At last
the micromixing time tm according to the incorporation model varied from 1.9 ms to 6.7 ms in our experiments.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.