Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe0.6Cu0.3Ti0.1O3-δ Membrane for Partial Oxidation of Methane to Syngas

董新法; 张恒; 林维明

Your Location：

Home >

Browse articles >

Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe_0.6Cu_0.3Ti_0.1O_3-δ Membrane for Partial Oxidation of Methane to Syngas

Updated：2026-01-06

- Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe_0.6Cu_0.3Ti_0.1O_3-δ Membrane for Partial Oxidation of Methane to Syngas
- Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe_0.6Cu_0.3Ti_0.1O_3-δ Membrane for Partial Oxidation of Methane to Syngas
- 中国化学工程学报（英文版） 2008年16卷第3期页码：411-415
- Affiliations：
  
  1. School of Chemical and Energy Engineering, South China University of Technology,Guangzhou,China,510640
  2. College of Chemistry Science, Qufu Normal University, Qufu,China,273165
- Author bio：
- Funds：
  
  Natural Science Foundation of Guangdong Province (030514);the Science and Technology Program ofGuangdong Province (2004B33401006)
- DOI：
  中图分类号：
- 纸质出版：2008
- Accepted：
Scan QR Code
董新法, 张恒, 林维明. Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe_0.6Cu_0.3Ti_0.1O_3-δ Membrane for Partial Oxidation of Methane to Syngas[J]. 中国化学工程学报（英文版）, 2008,16(3):411-415.

Cu
董新法, 张恒, 林维明. Preparation and Characterization of a Perovskite-type Mixed Conducting SrFe_0.6Cu_0.3Ti_0.1O_3-δ Membrane for Partial Oxidation of Methane to Syngas[J]. 中国化学工程学报（英文版）, 2008,16(3):411-415. DOI：

Cu DOI：

摘要

Dense membrane with the composition of SrFe

0.6

0.3

0.1

3-δ

(SFCTO)was prepared by solid state reaction method.Oxygen permeation flux through this membrane was investigated at operating temperature ranging from 750℃ to 950℃ and different oxygen partial pressure.XRD measurements indicated that the compound was able to form single-phased perovskite structure in which part of Fe was replaced by Cu and Ti.The oxygen desorption and the reducibility of SFCTO powder were characterized by thermogravimetric analysis and temperature programmed reduction analysis

respectively.It was found that SFCTO had good structure stability under low oxygen pressure at high temperature.The addition of Ti increased the reduction temperature of Cu and Fe.Performance tests showed that the oxygen permeation flux through a 1.5 mm thick SFCTO membrane was 0.35-0.96 ml·min

-1

·cm

-2

under air/helium oxygen partial pressure gradient with activation energy of 53.2 kJ·mol

-1

.The methane conversion of 85%

CO selectivity of 90%and comparatively higher oxygen permeation flux of 5 ml·min

-1

·cm

-2

were achieved at 850℃

when a SFCTO membrane reactor loaded with Ni-Ce/Al

catalyst was applied for the partial oxidation of methane to syngas.

Abstract

Dense membrane with the composition of SrFe

0.6

0.3

0.1

3-δ

(SFCTO) was prepared by solid state reaction method.Oxygen permeation flux through this membrane was investigated at operating temperature ranging from 750℃ to 950℃ and different oxygen partial pressure.XRD measurements indicated that the compound was able to form single-phased perovskite structure in which part of Fe was replaced by Cu and Ti.The oxygen desorption and the reducibility of SFCTO powder were characterized by thermogravimetric analysis and temperature programmed reduction analysis

-1

·cm

-2

under air/helium oxygen partial pressure gradient with activation energy of 53.2 kJ·mol

-1

.The methane conversion of 85%

CO selectivity of 90% and comparatively higher oxygen permeation flux of 5 ml·min

-1

·cm

-2

were achieved at 850℃

when a SFCTO membrane reactor loaded with Ni-Ce/Al

catalyst was applied for the partial oxidation of methane to syngas.

关键词

Keywords

references

浏览量

762

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Catalytic oxidation of methane for methanol production over copper sepiolite: Effect of noble metals

Oxygen vacancies enriched Ni-Co/SiO2@CeO2 redox catalyst for cycling methane partial oxidation and CO2 splitting

A Study of Acetylene Production by Methane Flaming in a Partial Oxidation Reactor

Preparation of anodic catalysts via in situ exsolution of Pt nanoparticles for a methane oxidation enhanced SOEC process

Research progress on the monolithic catalyst for hydrogenation of CO2 to methane