
FOLLOWUS
School of Carbon Neutrality Science and Engineering, Anhui University of Science and Technology, Hefei 230031, China
School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
Paris Elite Institute of Technology, Shanghai Jiao Tong University, Shanghai 200240, China
Corresponding author. E-mail address: chaoyzhang@sjtu.edu.cn(C. Zhang)
收稿:2025-09-28,
修回:2025-12-28,
录用:2025-12-30,
网络首发:2026-01-28,
纸质出版:2026-06
Scan QR Code
Wang Dahai, Yin Xianan, Zhao Chen, 等. Experimental study of flow boiling characteristics of ethylene glycol/water mixtures in titanium narrow-gap microchannel under sub-atmospheric pressure[J]. 中国化学工程学报(英文), 2026,94(6):1-16.
Wang Dahai, Yin Xianan, Zhao Chen, et al. Experimental study of flow boiling characteristics of ethylene glycol/water mixtures in titanium narrow-gap microchannel under sub-atmospheric pressure[J]. Chinese Journal of Chemical Engineering, 2026, 94(6): 1-16.
Wang Dahai, Yin Xianan, Zhao Chen, 等. Experimental study of flow boiling characteristics of ethylene glycol/water mixtures in titanium narrow-gap microchannel under sub-atmospheric pressure[J]. 中国化学工程学报(英文), 2026,94(6):1-16. DOI:
Wang Dahai, Yin Xianan, Zhao Chen, et al. Experimental study of flow boiling characteristics of ethylene glycol/water mixtures in titanium narrow-gap microchannel under sub-atmospheric pressure[J]. Chinese Journal of Chemical Engineering, 2026, 94(6): 1-16. DOI:
Narrow-gap channels offer strong heat transfer capability and structural stability
making them suitable for high-heat-flux cooling in compact systems. This study experimentally investigates the boiling performance of a titanium narrow-gap channel under sub-atmospheric pressure using an ethylene glycol-water mixture with a mass concentration of 55%. The effects of channel height
surface condition
mass flux
inlet subcooling
and saturation temperature were systematically examined
and bubbly flow
slug flow
and micro-bubble emission boiling were observed. Channel height strongly influenced boiling behavior: the 1.0 mm and 0.5 mm channels achieved significantly higher heat transfer coefficients than the 2.0 mm channel
while the 0.5 mm channel exhibited a much larger pressure drop
making the 1.0 mm channel the most practical configuration. Surface oxidation was identified as a major degradation factor
altering wettability
reducing nucleation-site activity
and causing periodic boiling crises that sharply reduced performance. Increasing mass flux improved the average heat transfer coefficient by enhancing convection and bubble removal
although the nucleate boiling enhancement factor decreased from 1.66 to 1.30 as nucleation became suppressed. Reducing the inlet subcooling from 30℃ to 20℃ promoted earlier boiling and more vigorous vapor generation
increasing the heat transfer coefficient by 65%. These results clarify how geometric
surface
and thermal-hydraulic parameters jointly control boiling in titanium narrow-gap channels and provide guidance for designing high-heat-flux cooling systems.
M.A. Ebadian, C.X. Lin, A review of high-heat-flux heat removal technologies, J. Heat Tran. 133 (11) (2011) 110801.
R. van Erp, R. Soleimanzadeh, L. Nela, G. Kampitsis, E. Matioli, Co-designing electronics with microfluidics for more sustainable cooling, Nature 585 (7824) (2020) 211-216.
L.X. Yang, A. Guo, W. Zhang, Computational fluid dynamics simulation of subcooled flow boiling in vertical rectangular 2-mm narrow channel, Adv. Mech. Eng. 7 (7) (2015) 1-12.
K. Zhou, C. Coyle, J.Y. Li, J. Buongiorno, W. Li, Flow boiling in vertical narrow microchannels of different surface wettability characteristics, Int. J. Heat Mass Tran. 109 (2017) 103-114.
R.A. Krishnan, K.R. Balasubramanian, S. Suresh, Experimental investigation of the effect of heat sink orientation on subcooled flow boiling performance in a rectangular microgap channel, Int. J. Heat Mass Tran. 120 (2018) 1341-1357.
T. Alam, P.S. Lee, C.R. Yap, L.W. Jin, A comparative study of flow boiling heat transfer and pressure drop characteristics in microgap and microchannel heat sink and an evaluation of microgap heat sink for hotspot mitigation, Int. J. Heat Mass Tran. 58 (1-2) (2013) 335-347.
W.H. Yu, D.M. France, D. Singh, W.H. Zhao, Experimental investigation of subcooled flow boiling of a 50/50 ethylene glycol/water mixture in finned rectangular aluminum channels, Exp. Heat Transf. 31 (6) (2018) 482-494.
X.Y. Hu, Y. Wang, S.Y. Li, Q. Sun, G.X. Li, S.Z. Bai, K. Sun, Investigation on subcooled flow boiling heat transfer characteristics in ICE-like conditions, Open Phys. 19 (1) (2021) 413-425.
W. Yu, D.M. France, W. Zhao, D. Singh, R.K. Smith, Subcooled flow boiling heat transfer to water and ethylene glycol/water mixtures in a bottom-heated tube, Exp. Heat Transf. 29 (5) (2016) 593-614.
J. Lee, L.E. O'Neill, S. Lee, I. Mudawar, Experimental and computational investigation on two-phase flow and heat transfer of highly subcooled flow boiling in vertical upflow, Int. J. Heat Mass Tran. 136 (2019) 1199-1216.
Z. Liu, R.H.S. Winterton, A general correlation for saturated and subcooled flow boiling in tubes and annuli, based on a nucleate pool boiling equation, Int. J. Heat Mass Tran. 34 (11) (1991) 2759-2766.
A.S. Pamitran, K.I. Choi, J.T. Oh, P. Hrnjak, Characteristics of two-phase flow pattern transitions and pressure drop of five refrigerants in horizontal circular small tubes, Int. J. Refrig. 33 (3) ( 2010) 578-588.
K. Wojtasik, R. Rullière, Z. Krolicki, B. Zajaczkowski, J. Bonjour, Subcooled boiling regime map for water at low saturation temperature and subatmospheric pressure, Exp. Therm. Fluid Sci. 118 (2020) 110150.
P.K. Das, S. Chakraborty, S. Bhaduri, Critical heat flux during flow boiling in mini and microchannel―a state of the art review, Front. Heat Mass Tran. 3 (1) (2012) 013008.
N. Colgan, J.L. Bottini, R. Martínez-Cuenca, C.S. Brooks, Experimental study of critical heat flux in flow boiling under subatmospheric pressure in a vertical square channel, Int. J. Heat Mass Tran. 130 (2019) 514-522.
C.P. Yin, Y.Y. Yan, T.F. Lin, B.C. Yang, Subcooled flow boiling heat transfer of R-134a and bubble characteristics in a horizontal annular duct, Int. J. Heat Mass Tran. 43 (11) (2000) 1885-1896.
W.R. Chang, C.A. Chen, J.H. Ke, T.F. Lin, Subcooled flow boiling heat transfer and associated bubble characteristics of FC-72 on a heated micro-pin-finned silicon chip, Int. J. Heat Mass Tran. 53 (23-24) (2010) 5605-5621.
J. Wang, K.H. Lu, S. Lu, H.J. Zhang, Experimental study on ceiling temperature profile of sidewall fires at reduced pressure in an aircraft cargo compartment, Exp. Therm. Fluid Sci. 82 (2017) 326-332.
Z. Rahimi-Ahar, M.S. H atamipour, Y. Ghalavand, A. Palizvan, Comprehensive study on vacuum humidification-dehumidification (VHDH) desalination, Appl. Therm. Eng. 169 (2020) 114944.
Z.Q. Xiong, C. Ye, M.L. Wang, H.Y. Gu, Experimental study on the sub-atmospheric loop heat pipe passive cooling system for spent fuel pool, Prog. Nucl. Energy 79 (2015) 40-47.
S.M. Peyghambarzadeh, S.H. Hashemabadi, S.M. Hoseini, M. Seifi Jamnani, Experimental study of heat transfer enhancement using water/ethylene glycol based nanofluids as a new coolant for car radiators, Int. Commun. Heat Mass Tran. 38 (9) (2011) 1283-1290.
C. Selvam, E.C. Muhammed Irshad, D.M. Lal, S. Harish, Convective heat transfer characteristics of water-ethylene glycol mixture with silver nanoparticles, Exp. Therm. Fluid Sci. 77 (2016) 188-196.
W.H. Azmi, K.A. Hamid, N.A. Usri, R. Mamat, K.V. Sharma, Heat transfer augmentation of ethylene glycol: water nanofluids and applications: a review, Int. Commun. Heat Mass Tran. 75 (2016) 13-23.
L.S. Sundar, M.K. Singh, A.C.M. Sousa, Thermal conductivity of ethylene glycol and water mixture based Fe 3 O 4 nanofluid, Int. Commun. Heat Mass Tran. 49 (2013) 17-24.
R.J. Moffat, Describing the uncertainties in experimental results, Exp. Therm. Fluid Sci. 1 (1) (1988) 3-17 .
P.H. Lin, B.R. Fu, C. Pan, Critical heat flux on flow boiling of methanol-water mixtures in a diverging microchannel with artificial cavities, Int. J. Heat Mass Tran. 54 (15-16) (2011) 3156-3166.
M.C. Vlachou, J.S. Lioumbas, K. David, D. Chasapis, T.D. Karapantsios, Effect of channel height and mass flux on highly subcooled horizontal flow boiling, Exp. Therm. Fluid Sci. 83 (2017) 157-168.
T. Alam, P.S. Lee, C.R. Yap, L.W. Jin, Experimental investigation of local flow boiling heat transfer and pressure drop characteristics in microgap channel, Int. J. Multiphas. Flow 42 (2012) 164-174.
M. Lee, L.S.L. Cheung, Y.K. Lee, Y. Zohar, Height effect on nucleation-site activity and size-dependent bubble dynamics in microchannel convective boiling, J. Micromech. Microeng. 15 (11) (2005) 2121-2129.
T.C. Willingham, I. Mudawar, Channel height effects on forced-convection boiling and critical heat flux from a linear array of discrete heat sources, Int. J. Heat Mass Tran. 35 (8) (1992) 1865-1880.
J.H. Seong, C. Wang, B. Phillips, M. Bucci, Separate effect of oxidation on the subcooled flow boiling performance of Zircaloy-4 at atmospheric pressure, Int. J. Heat Mass Tran. 188 (2022) 122620.
P. Jayaramu, S. Gedupudi , S.K. Das, An experimental investigation on the influence of copper ageing on flow boiling in a copper microchannel, Heat Transf. Eng. 41 (4) (2020) 333-350.
R.L. Ramakrishnan, P. Jayaramu, S. Gedupudi, S.K. Das, Experimental investigation of the influence of boiling-induced ageing on high heat flux flow boiling in a copper microchannel, Int. J. Heat Mass Tran. 181 (2021) 121862.
K. Wang, N. Erkan, K. Okamoto, A study on the effect of oxidation on critical heat flux in flow boiling with downward-faced carbon steel, Int. J. Heat Mass Tran. 147 (2020) 118966.
C.H. Wang, V.K. Dhir, Effect of surface wettability on active nucleation site density during pool boiling of water on a vertical surface, J. Heat Tran. 115 (3) (1993) 659-669.
F.W. Young, J.V. Cathcart, A.T. Gwathmey, The rates of oxidation of several faces of a single crystal of copper as determined with elliptically polarized light, Acta Metall. 4 (2) (1956) 145-152.
E. Lakew, A. Sarchami, G. Giustini, H. Kim, K. Bellur, Thin film evaporation modeling of the liquid microlayer region in a dewetting water bubble, Fluid 8 (4) (2023) 126.
L.F. Yin, A. Chauhan, A. Recinella, L. Jia, S.G. Kandlikar, Subcooled flow boiling in an expanding microgap with a hybrid microstructured surface, Int. J. Heat Mass Tran. 151 (2020) 119379.
H.T. Phan, N. Caney, P. Marty, S. Colasson, J. Gavillet, Flow boiling of water on nanocoated surfaces in a microchannel, J. Heat Tran. 134 (2) (2012) 020901.
V.P. Carey, Liquid-Vapor Phase-Change Phenomena: an Introduction to the Thermophysics of Vaporization and Condensation Processes in Heat Transfer Equipment, third ed., CRC Press, Boca Raton(2020).
0
浏览量
0
Downloads
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010102001993号