A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process

Sobhan Farahani; Mohammad Amin Sobati

doi:10.1016/j.cjche.2020.04.004

Your Location：

Home >

Browse articles >

A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process

Energy, Resources and Environmental Technology | Updated：2026-01-06

- A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process
- Chinese Journal of Chemical Engineering Vol. 28, Issue 9, Pages: 2447-2456(2020)
- Affiliations：
  
  School of Chemical Engineering, Iran University of Science and Technology (IUST), Tehran,Iran,16765-163
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2020.04.004
  CLC：
- Published：2020
- Accepted：
Scan QR Code
Sobhan Farahani, Mohammad Amin Sobati. A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process[J]. Chinese Journal of Chemical Engineering, 2020, 28(9): 2447-2456.
DOI：

Sobhan Farahani, Mohammad Amin Sobati. A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process[J]. Chinese Journal of Chemical Engineering, 2020, 28(9): 2447-2456. DOI： 10.1016/j.cjche.2020.04.004.

摘要

Abstract

The oxidative desulfurization (ODS) process is one of the new desulfurization processes for the production of clean fuels. Despite the benefits of the ODS process

this process faces several important challenges. One of the most important challenges of this process is the management of a waste which is rich of sulfone compounds. In the present study

a new strategy which is the addition of waste to the bitumen with other solid waste such as high density polyethylene (HDPE) waste has been investigated. The experimental design method was applied to investigate the effect of addition of the sulfone and HDPE wastes to the properties of the bitumen blends including degree of penetration

softening point

and mass loss. It was found that the sulfone waste can be added to the bitumen as a softener. The results showed that several grades of bitumen including 50/60

60/70

85/100 can be produced through the addition of sulfone waste along with the HDPE waste to the base 60/70 bitumen. In general

the application of simple processes such as mixing the wastes with the bitumen can reduce the cost of waste management

considerably.

关键词

Keywords

references

Views

203

Downloads

CSCD

Alert me when the article has been cited

Submit

Tools

Publicity Resources

Multi-objective optimization of wastewater treatment using electrocoagulation

Synthesis of boron nitride nanorod and its performance as a metal-free catalyst for oxidative desulfurization of diesel fuel

Polyamide-baghouse dust nanocomposite for removal of methylene blue and metals: Characterization, kinetic, thermodynamic and regeneration

Oxidative desulfurization of model and real oil samples using Mo supported on hierarchical alumina-silica: Process optimization by Box-Behnken experimental design

Deep oxidative desulfurization of gas oil based on sandwich-type polysilicotungstate supported β-cyclodextrin composite as an efficient heterogeneous catalyst

Related Author

Mohammed Rabeh Makhlouf

Imane Kouadri

Malek Bendjaballah

Sarra Hamidoud

Alimorad Rashidi

Gholamreza Moradi

Tanaz Ghanadi

Tawfik A. Saleh

Related Institution

Materials Engineering and Industrial Analysis Laboratory M. E. I. A. L. 8 May 1945, Guelma University, P. O 401

Catalyst Research Center, Faculty of Chemical and Petroleum Engineering, Razi University, Kermanshah

Nanotechnology Research Center, Research Institute of Petroleum Industry (RIPI), Tehran

Department of Civil and Environmental Engineering, King Fahd University of Petroleum and Mineral, Dhahran 31261, Saudi Arabia

Department of Chemistry, King Fahd University of Petroleum and Mineral, Dhahran 31261, Saudi Arabia

⁰