Catalytic depolymerization of calcium lignosulfonate by NiMgFeOx derived from sub-micron sized NiMgFe hydrotalcite prepared by introducing hydroxyl compounds
Biotechnology and Bioengineering|Updated:2026-01-06
|
Catalytic depolymerization of calcium lignosulfonate by NiMgFeOx derived from sub-micron sized NiMgFe hydrotalcite prepared by introducing hydroxyl compounds
Chinese Journal of Chemical EngineeringVol. 27, Issue 8, Pages: 1933-1938(2019)
Affiliations:
1. School of Chemistry & Chemical Engineering, Northeast Petroleum University,Daqing,China,163318
2. Heilongjiang Provincial Key Laboratory of Oil & Gas Chemical Technology,Daqing,China,163318
3. Shandong Sinocera Functional Material Co., Ltd,Dongying,China,257000
derived from sub-micron sized NiMgFe hydrotalcite prepared by introducing hydroxyl compounds[J]. 中国化学工程学报, 2019, 27(8): 1933-1938.
DOI:
derived from sub-micron sized NiMgFe hydrotalcite prepared by introducing hydroxyl compounds[J]. 中国化学工程学报, 2019, 27(8): 1933-1938.DOI: 10.1016/j.cjche.2019.01.024.
Catalytic depolymerization of calcium lignosulfonate by NiMgFeOx derived from sub-micron sized NiMgFe hydrotalcite prepared by introducing hydroxyl compounds
A new method for regulating the synthesis of NiMgFe hydrotalcites (NMF LDHs) with the addition of hydroxyl compounds was proposed. A series of NMF LDHs were prepared by the above method
and then were calcined to obtain the NiMgFeO
x
(NMFO
x
) samples. The NMFO
x
samples were characterized by XRD
SEM
TG-DTG
XPS and CO
2
-TPD
respectively. The catalytic performance of NMFO
x
for depolymerizing calcium lignosulfonate (CLS) was evaluated by hydrothermal reaction. The results showed that the addition of hydroxyl compounds favored reducing the particle sizes of NMF LDHs. For the depolymerization of CSL
the yield of liquid product increased from 45% to 75.8% with the addition of NMFO
x
-ethanol (NMFO
x
ET). The liquid products were mainly phenolics
aromatics
ketones and esters. The total selectivity of oxy-containing compounds was over 90.6%
among them
the phenolics were approximately 35.2%. The valence of Ni and Fe
crystalline phase and basicity almost remained unchanged. The NMFO
x
-ET sampl
es were recycled for the depolymerization of CLS
moreover
the NMFO
x
-ET samples had high activity and stability after 4 cycles.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Graphene oxide/hydrotalcite modified polyethersulfone nanohybrid membrane for the treatment of lead ion from battery industrial effluent
Effect of interlayer anions on chromium removal using Mg-Al layered double hydroxides: Kinetic, equilibrium and thermodynamic studies
Mathematical analysis of physicochemical phenomena in the catalyst during hydrogenating depolymerization of coal extract benzene insoluble fraction
Steam reforming of methane over Ni catalysts prepared from hydrotalcite-type precursors: Catalytic activity and reaction kinetics
Non-phosgene synthesis processes of isocyanates: One-step and two-step routes
Related Author
Sinu Poolachira
Sivasubramanian Velmurugan
Mohamed Khitous
Zineb Salem
Djamila Halliche
Jerzy Szczygie?
Marek Stolarski
Yang Qi
Related Institution
Department of Chemical Engineering, National Institute of Technology Calicut, Calicut 1
2 Laboratory of Natural Gas Chemistry, Institute of Chemistry, University of Sciences and Technology, Houari Boumediene, BP 32 El-Allia, Bab Ezzouar, Algiers
Department of Chemistry, Wroclaw University of Technology, ul. Gdańska 7/9
State Key Laboratory of Chemical Engineering, East China University of Science and Technology