Nickel(II) removal from water using silica-based hybrid adsorbents: Fabrication and adsorption kinetics

Min Xu; Junsheng Liu; Keyan Hu; Congyong Xu; Yaoyao Fang

doi:10.1016/j.cjche.2016.05.028

Your Location：

Home >

Browse articles >

Nickel(II) removal from water using silica-based hybrid adsorbents: Fabrication and adsorption kinetics

Separation Science and Engineering | Updated：2026-01-06

- Nickel(II) removal from water using silica-based hybrid adsorbents: Fabrication and adsorption kinetics
- Chinese Journal of Chemical Engineering Vol. 24, Issue 10, Pages: 1353-1359(2016)
- Affiliations：
  
  Key Laboratory of Membrane Materials and Processes, Department of Chemical and Materials Engineering, Hefei University, 99 Jinxiu Avenue,Hefei,China,230601
- Author bio：
- Funds：
- DOI：10.1016/j.cjche.2016.05.028
  CLC：
- Published：2016
- Accepted：
Scan QR Code
Min Xu, Junsheng Liu, Keyan Hu, Congyong Xu, Yaoyao Fang. Nickel(II) removal from water using silica-based hybrid adsorbents: Fabrication and adsorption kinetics[J]. , 2016, 24(10): 1353-1359.
DOI：

Min Xu, Junsheng Liu, Keyan Hu, Congyong Xu, Yaoyao Fang. Nickel(II) removal from water using silica-based hybrid adsorbents: Fabrication and adsorption kinetics[J]. , 2016, 24(10): 1353-1359. DOI： 10.1016/j.cjche.2016.05.028.

摘要

Abstract

A series of novel silica-based hybrid adsorbents were prepared by the crosslinking reaction of

-[3-(trimethoxysilyl)propyl

]

ethylene diamine (TMSPEDA)with epichlorohydrin (ECH)

via

a sol-gel process. Fourier transforminfrared (FTIR) spectra confirmed that the reaction occurred. TGA curves showed that the thermal stability of these hybrid adsorbents reached as high as 180℃. As a typical example

the adsorption performance of nickel(II) ions onto an adsorbent (the volume ratio of TMSPEDA and ECH was 4:1) was explored. It was found that the adsorption of nickel(II) ions onto this adsorbent followed the Lagergren pseudo-second-order kinetic model. The investigation of the adsorption mechanism demonstrated that nickel(II) adsorption was chiefly controlled by diffusion-chemisorption

suggesting that more diffusion processes were involved in the adsorption of nickel(II) ions onto this type of adsorbents. Desorption experiment indicates that these hybrid adsorbents can be regenerated. These findings reveal that this type of silica-based hybrid adsorbent is promising in the separation and recovery of nickel(II) ions from Ni-containing wastewater or contaminated water.

关键词

Keywords

references

Views

198

Downloads

CSCD

Alert me when the article has been cited

Submit

Tools

Publicity Resources

Removal of strontium ions from aqueous solution using hybrid membranes: Kinetics and thermodynamics

Kinetics of hydrogen sulfide removal from coke oven gas over faujasite zeolite: Experimental and modeling studies

Adsorption of ciprofloxacin on (Zn-Al) LDHs modified 3D reduced graphene oxide: Response surface methodology, adsorption equilibrium, kinetic and thermodynamic studies

Studies on ammonium dinitramide and 3,4-diaminofurazan cocrystal for tuning the hygroscopicity

Boosting kinetic separation of ethylene and ethane on microporous materials via crystal size control

Related Author

Zhicheng Chu

Junsheng Liu

Chengliang Han

Feng Gao

Sixiao Zhu

Liping Chang

Weiren Bao

Jinghong Ma

Related Institution

Key Laboratory of Membrane Materials & Processes, Department of Chemical and Materials Engineering, Hefei University

State Key Laboratory of Clean and Efficient Coal Utilization, Taiyuan University of Technology

Key Laboratory of Coal Science and Technology, Ministry of Education, Taiyuan University of Technology

School of Chemistry and Chemical Engineering, Taiyuan University of Technology

Zheda Institute of Advanced Materials and Chemical Engineering

⁰