Performance Appraisal of Controlled Low-strength Material Using Sewage Sludge and Refuse Incineration Bottom Ash
|Updated:2026-01-06
|
Performance Appraisal of Controlled Low-strength Material Using Sewage Sludge and Refuse Incineration Bottom Ash
Chinese Journal of Chemical EngineeringVol. 20, Issue 1, Pages: 80-88(2012)
Affiliations:
1. The State Key Laboratory of Pollution Control and Resource Reuse, School of Environmental Science and Engi-neering, Tongji University,Shanghai,China,200092
This research evaluated the use of sewage sludge and refuse incineration bottom ash to replace calcium sulfoaluminate cement(CSA) in making controlled low-strength material(CLSM).Various properties of CLSM mixtures were characterized in terms of unconfined compressive strength
microstructure and leachability.It was found that the strength of tested CLSM mixtures ranged from 3.6 to 9.0 MPa
over the upper excavatable limit of 2.1 MPa.The micro-structural analysis revealed that sewage sludge and bottom ash were crystallochemically incorporated within CLSM systems by forming the needle-like ettringite(C
3
A·3CS·H
32
) with exiguous tubers via the typical Pozzolanic Reaction
leading to a dense and low-porosity microstructure.Furthermore
the toxicity characteristic leaching procedure evidenced that the cumulative leachable metals in the leachate were much below the regulatory thresholds.The potential for using sewage sludge and bottom ash in CLSM making was thus confirmed.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.