Rapid and Continuous Production of LiFePO<sub>4</sub>/C Nanoparticles in Super Heated Water

于文利; 赵亚平; 饶群力

doi:10.1016/S1004-9541(09)60051-3

Your Location：

Home >

Browse articles >

Rapid and Continuous Production of LiFePO₄/C Nanoparticles in Super Heated Water

Updated：2026-01-06

- Rapid and Continuous Production of LiFePO₄/C Nanoparticles in Super Heated Water
- Chinese Journal of Chemical Engineering Vol. 17, Issue 1, Pages: 171-174(2009)
- Affiliations：
  
  1. School of Chemistry and Chemical Technology, Shanghai Jiao Tong University,Shanghai,China,200240
  2. Instrumental Analysis Centre, Shanghai Jiao Tong University,Shanghai,China,200240
- Author bio：
- Funds：
- DOI：10.1016/S1004-9541(09)60051-3
  CLC：
- Published：2009
- Accepted：
Scan QR Code
/C Nanoparticles in Super Heated Water[J]. , 2009, 17(1): 171-174.
DOI：

/C Nanoparticles in Super Heated Water[J]. , 2009, 17(1): 171-174. DOI： 10.1016/S1004-9541(09)60051-3.

摘要

A rapid and continuous method for production of LiFePO

/C nanoparticles in super heated water is described

wherein soluble starch was used as carbon precursor.The effects of pH

flow rate

temperature

and pressure on the formation of LiFePO

/C particles were investigated.Results showed that the pH value was the key factor on the formation of phase pure LiFePO

which only formed at pH=7;the LiFePO

/C occurred as particles with about 70-200 nm size and LiFePO

was covered by a thin carbon layer;higher flow rate

higher pressure

and lower temperature led to smaller particles of LiFePO

/C.

Abstract

A rapid and continuous method for production of LiFePO

/C nanoparticles in super heated water is described

wherein soluble starch was used as carbon precursor.The effects of pH

flow rate

temperature

and pressure on the formation of LiFePO

/C particles were investigated.Results showed that the pH value was the key factor on the formation of phase pure LiFePO

which only formed at pH=7;the LiFePO

/C occurred as particles with about 70-200 nm size and LiFePO

was covered by a thin carbon layer;higher flow rate

higher pressure

and lower temperature led to smaller particles of LiFePO

/C.

关键词

Keywords

references

Views

183

Downloads

CSCD

Alert me when the article has been cited

Submit

Tools

Publicity Resources

Low-temperature conversion of methane to oxygenates by supported metal catalysts: From nanoparticles to single atoms

Fabrication of a highly efficient new nanocomposite polymer gel for controlling the excess water production in petroleum reservoirs and increasing the performance of enhanced oil recovery processes

Experimental study on thermo-hydraulic performances of nanofluids flowing through a corrugated tube filled with copper foam in heat exchange systems

Review on application of nanoparticles for EOR purposes: A critical review of the opportunities and challenges

Influence of nanoparticle concentrations on flow boiling heat transfer coefficients of Al2O3/R141b in micro heat exchanger by direct metal laser sintering

Related Author

Xiaodong Wang

Jian Lin

Geqian Fang

Bahman ZareNezhad

Shahab Ayatollahi

Sajad Asadizadeh

Cong Qi

Yongliang Wan

Related Institution

CAS Key Laboratory of Science and Technology on Applied Catalysis, Dalian Institute of Chemical Physics, Chinese Academy of Sciences

University of Chinese Academy of Sciences

Faculty of Chemical, Petroleum and Gas Engineering, Semnan University, Semnan

Chemical and Petroleum Engineering Department, Sharif University of Technology, Tehran

2 School of Electrical and Power Engineering, China University of Mining and Technology

⁰

Rapid and Continuous Production of LiFePO4/C Nanoparticles in Super Heated Water

DOI：10.1016/S1004-9541(09)60051-3

摘要

Abstract

关键词

Keywords

references

Rapid and Continuous Production of LiFePO₄/C Nanoparticles in Super Heated Water