In situ investigation of lysozyme adsorption into polyelectrolyte brushes by quartz crystal microbalance with dissipation
|Updated:2026-01-06
|
In situ investigation of lysozyme adsorption into polyelectrolyte brushes by quartz crystal microbalance with dissipation
Chinese Journal of Chemical EngineeringVol. 48, Issue 8, Pages: 106-115(2022)
Affiliations:
1. Department of Biochemical Engineering, School of Chemical Engineering and Technology, Tianjin University,Tianjin,China,300350
2. Key Laboratory of Systems Bioengineering (Ministry of Education), Tianjin University,Tianjin,China,300072
Author bio:
Funds:
DOI:
CLC:
Published:2022
Accepted:
Scan QR Code
investigation of lysozyme adsorption into polyelectrolyte brushes by quartz crystal microbalance with dissipation[J]. 中国化学工程学报, 2022, 48(8): 106-115.
DOI:
investigation of lysozyme adsorption into polyelectrolyte brushes by quartz crystal microbalance with dissipation[J]. 中国化学工程学报, 2022, 48(8): 106-115.DOI:
In situ investigation of lysozyme adsorption into polyelectrolyte brushes by quartz crystal microbalance with dissipation
A well understanding about protein adsorption into charged polymer brushes is of importance in the elucidation of mechanism and important phenomena (such as “chain delivery” effect) in protein adsorption on polymer-grafted ion exchange adsorbents. In this work
quartz crystal microbalance with dissipation (QCM-D) was introduced to
in situ
investigate lysozyme adsorption on QCM sensors grafted with poly(3-sulfopropyl methacrylate) (
p
SPM)
via
atom transfer radical polymerization. It was achieved by analyzing frequency (
f
) and energy dissipation (
D
) shift simultaneously on
p
SPM-grafted sensors. The result showed that an initial decrease in Δ
D
was typical of lysozyme adsorption on
p
SPM-grafted sensor and more significant with an increase of chain length and grafting density. It was attributed to significant water release in the hydration layer of protein and polymer chains in lysozyme adsorption into
p
SPM brushes. On
p
SPM-grafted sensors with long and dense chains
furthermore
lysozyme transitioned from monolayer to multilayer adsorption and the maximum adsorbed amount was obtained to be 374.0?ng·cm
?2
among all
p
SPM-grafted sensors in this work. The results in
D
-
f
plot further revealed that lysozyme adsorption into
p
SPM brushes increased the rigidity of adsorbed layer and little structure adjustment of adsorbed lysozyme. It was unfavorable for “chain
delivery” effect for facilitated transport of adsorbed protein. This work provided valuable insight into protein adsorption in
p
SPM brushes and outlined a feasible approach to increasing mass transport in polymer-grafted ion exchange adsorbents.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Protein-derived nitrogen and sulfur co-doped carbon for efficient adsorptive removal of heavy metals
COS generation behavior during desulfurization for H2S over zeolite in simulated blast furnace gas
Ultra-efficient selective removal of 99TcO4-/ReO4- via self-polymerizing cationic organic polymer: Adsorption performance and mechanistic insight
Imidazole-based porous organic polymers featuring hydrogen bond donors as environmentally friendly heterogeneous catalysts for efficient CO2 conversion
Synthesis of ZSM-5 zeolite from desiliconization solution of coal fly ash and adsorption properties of Pb2+ containing wastewater
Related Author
Yawei Shi
Wei Zheng
Hao Liu
Liang Wang
Hongwei Zhang
Guo Yan
Hou Tuanyuan
Wang Yongjin
Related Institution
State Key Laboratory of Separation Membranes and Membrane Processes, Tianjin Polytechnic University
School of Environmental and Chemical Engineering, Tianjin Polytechnic University
State Key Laboratory of Clean and Efficient Coal Utilization, Taiyuan University of Technology
College of Chemistry and Chemical Engineering, Xinjiang Normal University
Key Laboratory of Coal Science and Technology, Ministry of Education, Taiyuan University of Technology