SCI和EI收录∣中国化工学会会刊

Chinese Journal of Chemical Engineering ›› 2019, Vol. 27 ›› Issue (3): 501-513.DOI: 10.1016/j.cjche.2018.08.009

• Fluid Dynamics and Transport Phenomena • 上一篇    下一篇

Influence of heat flux and Reynolds number on the entropy generation for different types of nanofluids in a hexagon microchannel heat sink

A.A. Alfaryjat, A. Dobrovicescu, D. Stanciu   

  1. Faculty of Mechanical Engineering and Mechatronics, University Politehnica of Bucharest, Splaiul Independentei nr. 313, sector 6, Bucuresti, Romania
  • 收稿日期:2018-04-11 修回日期:2018-08-08 出版日期:2019-03-28 发布日期:2019-04-25
  • 通讯作者: A.A.Alfaryjat,E-mail addresses:altayyeb.al@stud.mec.upb.ro;A.Dobrovicescu,E-mail addresses:adobrovicescu@yahoo.com

Influence of heat flux and Reynolds number on the entropy generation for different types of nanofluids in a hexagon microchannel heat sink

A.A. Alfaryjat, A. Dobrovicescu, D. Stanciu   

  1. Faculty of Mechanical Engineering and Mechatronics, University Politehnica of Bucharest, Splaiul Independentei nr. 313, sector 6, Bucuresti, Romania
  • Received:2018-04-11 Revised:2018-08-08 Online:2019-03-28 Published:2019-04-25
  • Contact: A.A.Alfaryjat,E-mail addresses:altayyeb.al@stud.mec.upb.ro;A.Dobrovicescu,E-mail addresses:adobrovicescu@yahoo.com

摘要: Based on the Second Law of Thermodynamics, the entropy generation is studied for laminar forced convection flow of different nanoparticles (Al2O3, CuO and SiO2) mixed with water through a hexagon microchannel heat sink (HMCHS). The effects of different heat fluxes and Reynolds numbers on the entropy generation for different nanofluids, volume fractions and nanoparticles diameter are investigated. The heat flux is in the range of 125 to 500 kW·m-2 and the Reynolds numbers vary between 200 and 1500. The thermal, frictional and total entropy generations are calculated by integrating the volumetric rate components over the entire HMCHS. The results clearly show that the rise in the heat flux leads to an increase in the thermal entropy generation for nanofluids and pure water but they don't have any influence on the frictional entropy generation. Moreover, when the Reynolds number increases, the frictional entropy generation increases while the thermal entropy generation decreases. The results revealed that at low heat fluxes and high Reynolds numbers, pure water gives the lowest entropy generation, while at high heat flux the nanofluid has to be used in order to lower the overall irreversibility.

关键词: Microchannel heat sink, Nanofluids, Entropy generation, Numerical analysis, Laminar flow

Abstract: Based on the Second Law of Thermodynamics, the entropy generation is studied for laminar forced convection flow of different nanoparticles (Al2O3, CuO and SiO2) mixed with water through a hexagon microchannel heat sink (HMCHS). The effects of different heat fluxes and Reynolds numbers on the entropy generation for different nanofluids, volume fractions and nanoparticles diameter are investigated. The heat flux is in the range of 125 to 500 kW·m-2 and the Reynolds numbers vary between 200 and 1500. The thermal, frictional and total entropy generations are calculated by integrating the volumetric rate components over the entire HMCHS. The results clearly show that the rise in the heat flux leads to an increase in the thermal entropy generation for nanofluids and pure water but they don't have any influence on the frictional entropy generation. Moreover, when the Reynolds number increases, the frictional entropy generation increases while the thermal entropy generation decreases. The results revealed that at low heat fluxes and high Reynolds numbers, pure water gives the lowest entropy generation, while at high heat flux the nanofluid has to be used in order to lower the overall irreversibility.

Key words: Microchannel heat sink, Nanofluids, Entropy generation, Numerical analysis, Laminar flow